FPV Setup Guide 

This is the Multi Rotor Fpv setup guide that will go threw the making of parts as well as the wiring of the power system even building of a HMD(Head Mounted Display )

5.8G FPV Setup Part 2 LC Filter & Regulator

now this is the circuit diagram 

this is the strip board you will need to cut for a lc filter 

this is the parts list 

LC Filter Parts List 
1 x ferrite ring (off esc)
1 x 470uf 25v electrostatic capacitor
1 x led (colour is ur choice)
1 x 470ohm or 1k resistor
also some wire to hook up the parts and wind the coil  

 

 

LC Filter Regulator Parts List 
1 x ferrite ring (off esc)
1 x lm7809 (or equivalent )
1 x 10uf capacitor (input side )
1 x 220uf capacitor (for output side )
1 x led (colour is ur choice)
1 x 470ohm or 1k resistor   
also some wire to hook up the parts and wind the coil  

 

 

here are my builds of the lc filter and the regulator

 

ALSO CHECK OUT MY SITE FOR MORE STUFF 

- See more at: http://flitetest.com/articles/5-8g-fpv-setup-part-2-lc-filter-regulatos#sthash.Azk0xHw8.dpuf 

5.8G FPV Setup Part 1 Antennas  

 so in this video i will cover how to make a 5.8g circular polarized antenna .

these are a few pics of my antennas 

in the next video we will be coveing lc filters with a built in led indicator so you know ur system has power 

enjoy and i hope this helps you with your setup